Declaration Of Conformity; After-Sales Service - elc AL 781NX Bedienungsanweisungen

6.3.3 Cautions
Before applying the load, always set the power supply. Connect the load using isolated
cords with sufficient diameter. Disconnect the load before switching off the power
supply. Keep the instrument away from dust.
Any interruption of the protective conductor outside the case or any
disconnecting of the earth terminal may render the instrument dangerous.
The intentional interruption is forbidden.
6.4 APPLICATIONS
As outputs are floating, limited by the maximum common voltage, the reference is
given by the mounting diagram (Fig. 2).
The power supply can deliver a positive or negative voltage.
7. MAINTENANCE
No particular maintenance is required for this instrument.
Avoid dust, moisture, shocks ; your instrument will be grateful for that.
For the cleaning, please use a smooth duster.
If indicators do not light up on switching on, check :
- That the «ON/OFF» switch is pressed
- The mains voltage
- The connection to mains
- The protective fuse.
8. AFTER SALES SERVICE
The after sales Service is ensured by the elc company.
During one year, spare parts and workmanship are guaranteed. This guarantee does
not apply to instruments presenting defects or failures caused by an improper use
(wrong mains voltage, shocks ...) or which have been repaired outside our factory
or the repair shops of our authorized agencies.

9. DECLARATION OF CONFORMITY

according to ISO / IEC guide 22 and EN45014
Manufacturer : elc
Address : 59, av. des Romains - 74000 Annecy - France
declares the product
Name : Stabilized Power-supply
Number : AL781NX
conformable to following specifications :
Safety : EN61010-1 : 2001
EMC : EN 61326-1 : 2006
Further information :
The product above is conformable to the requirements of the «Low Voltage» directive
2006/95/CE and of the «Electromagnetic Compatibility» directive 2004/108/CE.
Annecy, October 29th, 2008
Henri Curri, manager
ELIMINATION OF MANUFACTURING WASTES BY THE PRIVATE
USERS IN THE EU
This symbol written in the product or in its packaging indicates
that this product must not be throw in the garbage with your other
waste.
Its your responsability to rid of your manufacturing wastes
bringing it to a specialized sorting office for the recycling of
electrical and electronic instruments.
Collection and recycling separated of your wastes will contribute
to preserve natural resources and guarantee a recycling
respectful of the Environment and human health.
For further information concerning the recycling center near your place of residence,
contact your town hall, the elimination service of garbage heap or the store where
you bought the instrument.
- 10 -