Sage Nutri Juicer BJE410 Kurzanleitung Seite 12

TROUBLESHOOTING
POSSIBLE PROBLEM
Pulp too wet and
reduced extracted juice
Juice leaks between the
rim of the Juicer and the
juicer cover
Juice sprays out
from spout
Overheating with
excessive loads.
12
EASY SOLUTION
• Try a slower juicing action. Remove the stainless steel filter
basket and thoroughly clean mesh walls with a cleaning
brush. Rinse the filter basket under hot water. If the fine
mesh holes are blocked, soak the basket in a solution of hot
water with 10% lemon juice to unlock the holes or wash in
the dishwasher. This will remove excess fibre build up (from
fruit and vegetables) which could be inhibiting the flow.
• Try a slower juicing speed and push the food pusher down
the feed chute more slowly.
• Ensure all parts are securely pieced together, with the
interlocking arm in place.
• The juice is being extracted too fast: try a slower juicing
speed and push the food pusher down the feed chute
more slowly.
• The juicer is fitted with a safety device which safeguards
against overheating with excessive loads. If overheating
occurs, the juicer will automatically activate the overload
protection device and the unit will switch itself off. When the
overload protection is activated, unplug the Juicer from the
power outlet for at least 15 minutes to allow the unit to cool.
Then plug the juicer into the power outlet and use as normal.
• It is important to ensure the juicer is turned on and the motor
is running prior to loading the chute. Do not put excessive
loads in the feed chute and ensure the filter basket is totally
clear of any food build up, on the blades and mesh, as this
can result in unnecessary resistance against the motor
resulting in overheating.