Yada BT53328F-1 Einbauanleitung Seite 31

See Below. You can also watch some common installation videos at www.letsyada.com for more information.
Caution: This unit is designed to operate on a 12V/24V DC NEGATIVE GROUND electrical system. Connecting
to other types of electrical systems will cause damage to your vehicle. Please contact the manufacturer if
you are unaware of the system type in your vehicle.
1. Remove your license plate
2. Determine the best route for the Camera Cable from the top of your license plate to the inside of the
vehicle.. You may need to drill a small hole in the panel behind where the license plate is situated.
3. Take the Camera and run the cable through the Rubber Ring Grommet, then from the outside of your car
to the inside . Pull the cable through so that there is a small amount of slack and you can still move the
Camera around the license plate.
4. Locate the reverse taillights wiring behind your reverse light. You may need to remove the interior
panel in order to locate. You only need to attach the Camera to ONE of the reverse lights, not both. If
you cannot manually locate the tail light cables, please contact the vehicle manufacturer or reference a
wiring diagram for your vehicle.
5. At your taillight, remove the light bulb socket from the reverse light housing.
6. D etermine the reverse light power wires for your car, designating the positive and negative wires. If you
are not sure of which are the power wires, then please contact your vehicle manufacturer or reference a
wiring diagram for your vehicle.
7. Connecting the Camera Power Cable:
a. Take the open wire end of this cable, and connect it to the power wires of your car (as determined
in step 4). Using the Snap Lock Splice Connectors, connect the Camera's Red wire to reverse light's
Positive wire. Connect the camera's Black Wire to reverse light's Negative wire.
b. Use pliers to squeeze the metal tabs of the Snap Lock Splice Connectors and ensure a solid connection,
then snap the plastic cover closed.
8. While sitting in the driver's seat of the car with the key in the accessory position. The monitor will
automatically start when connected to a power source. If when you place the vehicle in reverse there is
no image, go to the section "Pair and Connection" for more information.
9. Put the vehicle in reverse. If you have a clear picture, put the vehicle back in park and turn the key to the
off position. You are now ready for final steps.
10. Use the provided Zip ties to secure wires neatly within your car.
11. Replace the light socket back into the reverse light housing.
12. Replace any interior panels that may have been removed to access the taillight and close your trunk or
5