cloth soaked in warm water and a degreasing agent,
•
and then dry. Do not use agents which could scratch the surface.
•
Set the stove at a firm and stable floor in a room that is suitable for the stove to operate in, compliant
with building regulations, and then level with adjustable feet (Fig. 4).
Conditions for connection to mains:
•
Make sure that the mains voltage corresponds to the voltage indicated on the rating plate of the ap-
pliance (5 Pos. 3)
•
To connect the appliance to the mains, connect the power cord to the terminal box at the bottom of
the appliance (Fig. 5 Pos. 2). The power cord with plug is NOT part of the kit and must be purchased.
•
The device must be connected to an equipotential equalization system using the equipotential screw
(Fig. 5 Pos. 1) located at the bottom of the device at the terminal box. It is marked with the following
symbol:
Figure 5. Rear view of unit
The power cord should be flexible, oil-resistant, earthed, polychloroprene-coated - it can be made by the
manufacturer and available from him or in specialist repair shops!
Figure 4. Leveling the device
- 21 -
Rear panel components:
1. Equipotential bolt
2. Terminal box
3. Rating plate