Werbung
(schwarze Klemme auf Minus-Pol, rote Klemme auf Plus-Pol der Batterie)
7. Pumpe einschalten (4) und absaugen.
8. Nach Beendigung des Absaugvorganges schalten Sie die Pumpe wieder ab. Lassen Sie die Pumpe
niemals „Trockenlaufen".
9. Füllen Sie lt. Kfz-Hersteller neues Motoröl in Ihr Fahrzeug ein. Danach kontrollieren Sie mit dem Öl-
Meßstab den Ölstand.
Hinweis: Nach Beendigung der Arbeit Pumpe samt Zubehör sorgfältig reinigen und staubgeschützt
lagern.
Entsorgungshinweise:
Die Öl-Absaugpumpe ist ein Elektrogerät. Ein defektes Elektrogerät muss bei den örtlichen Sammelstellen für
Elektro- und Elektronikschrott entsorgt werden und gehört nicht in den Hausmüll.
Kontaktinformationen
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
Deutschland
GB Art. No 21014
Oil pump
Use Instructions
Dear customers!
Before using this product, please read the Use Instructions and follow them carefully. Keep the Use
Instructions for further reference.
Product description:
This oil pump is designed for clean replacing of oil and/or draining engine oil, diesel or fuel oil.
1. Pumping hose ø 6 mm
2. Oil pump
3. Outlet hose ø 12 mm
4. ON/OFF switch
5. Power cord with battery clips 12V
Safety warnings:
- Before use make sure that the pump, the hoses and the cable are in perfect condition.
or connections should be replaced only by authorized qualified persons
- Children must not play with the appliance. Cleaning and user maintenance tasks must not be carried out
by children unless they are supervised.
- Do not perform any modification or dismount the device by yourself.
- Ensure that the hoses and cables can not be damaged by sharp edges and can not get in contact with
hot surfaces.
- Do not pump gasoline, kerosene or other highly flammable liquids! EXPLOSION HAZARD!
- Do not pump water or gear oil: this may cause damage to the pump.
- When connecting the battery clips, keep correct polarity!
- Always switch the engine off when pumping.
- Always heat engine oil up before pumping!
- Never let the pump "running idle" When oil pumping is interrupted, switch the pump off immediately.
- Collect the used oil in a container of sufficient capacity. Make sure that oil does not leak into earth or
sewerage! Dispose of in a used oil disposal facility!!!
Caution:
The oil pump is designed to run for approx. 15 minutes. After that, let the pump cool down.
Oil pump Use Instructions:
1. Before replacing oil, heat the engine up until the temperature reaches approx. 40 - 60°C.
2. Switch off the engine!!
3. Remove the protection caps from the sockets. Insert the pumping hose (1) in the suction neck and insert
the outlet hose in the outlet neck of the pump. To make sure that the hoses do not let loose, fasten them
using the clips supplied.
4. Insert the pumping well (1) into the oil-gauge hole down to the deepest point of the engine sump.
Telefon: +49 (0)202 42 92 83 0
Telefax: +49 (0)202 2 65 57 98
Internet: www.eal-vertrieb.de
E-Mail: info@eal-vertrieb.com
3
D amaged cables
Werbung
