Setting Up The Device; Fitting The Batteries; Connecting A Power Pack - Conrad MINI Lion Bedienungsanleitung

Setting up the device

Before starting to operate, please read carefully the
section relating to regulation use of the device, and
also the Notes on Safety and technical data.
Back view
ON OFF
DC
9V

Fitting the batteries:

Operating the Water Fountain requires two Mignon batteries (1.5V,
type AA).
This is how you fit the batteries:
Slide back the battery compartment cover, as shown in the figure,
and fit two 1.5V Mignon batteries into the Water Fountain.
Make sure that the batteries are fitted the right way round (cor-
rect polarity is shown in the figure)!
When you have fitted the batteries, slide back the battery compart-
ment cover over the battery compartment.
6
Never leave unconsumed batteries in the Water Fo-
untain. Even leak-proof batteries can corrode and
may thus release chemicals which are a health ha-
zard and may irreparably damage the battery com-
partment. Fitting batteries the wrong way round (in-
correct polarity) will irreparably damage the Water
Fountain.
Environmentally important!
As consumer of the product, you are legally requi-
red (regulation relating to used batteries) to return
all used batteries and rechargeable batteries (from
button cell to lead battery). Disposal in domestic
waste is illegal.
You can dispose of your used batteries and rechar-
geable batteries by returning them free of charge to
our facility in Hirschau, or, as previously, to local
disposal centers (recycling centers), which are obli-
ged to accept them.
Act to protect the environment!

Connecting a power pack:

If the Water Fountain is supplied from a power pack, the batte-
ries must be removed from the device! When operating the Wa-
ter Fountain via a power pack, observe the safety instructions
of the manufacturer of the power pack. Never bring the power
pack into contact with water.
The Water Fountain can also be supplied from a DC power pack.
The maximum voltage that the power pack may deliver is 9V DC,
with a continuous output current of 300mA. The power pack must
7