Switching on the intermediate stage/
28
deleting a transmitter
Switching on the intermediate stage
!
P R E R E Q U I S I T E !
The transmitter is now programmed.
1. Briefly press the v button twice in succession.
The radiant heater heats with approx. 66% of its rated power.
2. Briefly press the b button twice in succession.
The radiant heater heats with approx. 50% of its rated power.
Deleting individual transmitters
1. Press simultaneously:
• Programming button P
i
on the programmed transmitter
• STOP button
2. Hold down this button combination until the LED goes out briefly
3 times.
Deleting all transmitters
1. Press simultaneously:
• Programming button P
i
• v-button
on the programmed transmitter
• STOP button
• b-button
2. Hold down this button combination until the LED goes out briefly
3 times.
Technical data/notes on troubleshooting
Technical data
Mains voltage
Frequency
Max. connected power
IP Code
Permitted
ambient temperature
Cables
Back-up fuse
Max. number of programmable
transmitters per receiver
I M P O R T A N T !
Pay attention to the rated power of the radiant heater!
Notes on troubleshooting
Fault
Cause
No radio reception
1. Transmitter is not
programmed.
2. No power supply.
Bad radio reception
Unfavourable
position
of receiver.
Heating does not
1. Radiant heater
heat up
wrongly connected .
2. Heating element
is defective.
29
230 V
50 Hz
2000 W
IP 54
–20 °C to +30 °C
Mains cable 490 mm (STAS 3)
Cable to heating 235 mm (STAK 3)
16 A time delay
16
Remedy
1. Program the
transmitter.
2. Switch on
power supply.
Change position
of receiver
or aerial.
1. Check
connection.
2. Replace heating
element.