Programming additional transmitters
26
N O T E !
If several receivers are connected to the same feed line,
then all are simultaneously ready to program.
The radiant heater begins to briefly light up 'at random' .
The longer you wait with the programming the greater
will be the offset.
Individual channels/transmitters can now be assigned to
the respective receiver.
You can stop the flashing if you briefly push the STOP
button of a transmitter which has already been
programmed.
The channel assignment/change can now be made
without you having to disconnect the individual
receivers.
Switching the radiant heater on/off
Switching on the heating system
!
P R E R E Q U I S I T E !
The transmitter is now programmed.
Press the v or b button.
Switching off the heating system
Press the STOP button.
N O T E !
The IR Radio Dimmer 2000 automatically switches the
connected radiant heater(s) off after 12 hours.
27