Spare Parts Overview; Maintenance And Care - GAUI 500X-S Bedienungsanleitung

12. Spare Parts Overview

Page P.23
Pages P.23 and P.24 show the spare parts available from the manufacturer with their respective designations and the
associated spare parts numbers.
Attention!
Please observe that the 6-digit numbers in the manufacturer's manual are no Conrad order numbers!
For the current list of spare parts with the corresponding Conrad Electronic order numbers, see www.conrad.com, in the
download area of the model.

13. Maintenance and Care

To warrant operational safety of your model, regular inspections and maintenance are required.
1. Check if any screws have loosened or components are no longer firmly screwed or glued on.
2. Observe the clean concentric dunning and firm seat of the propellers. The propellers must not show any visible damage.
3. Check that the motors run smoothly. If manual rotation causes a „rolling" or „gnashing" feeling, the respective motor
must be replaced.
4. Check the correct and secure fit of the adhesive pads and 3-axis gyro system. Loose or wobbly gyro systems lead to
uncontrolled movements of the quadrocopter.
5. Check all cables. Especially observe the connections between the speed controllers and the motors.
Important!
If you have to replace any damaged or worn parts, only use genuine replacement parts in your quadrocopter.
The spare parts list is located on our website www.conrad.com in the download section to the respective product.
Alternatively, you may also request the spare parts list on the phone. For the contact data, please refer to the top of these
instructions in the chapter „Introduction".
42