System Settings - GAUI 500X-S Bedienungsanleitung

9. System Settings

Page P.12
1. Model selection
If the remote control transmitter used by you permits switching between helicopter and wing models, select the model type
„flight model" since the quadrocopter does not need any mixer function in the transmitter.
2. Selection of the direction functions
If one you use one of the transmitters from the table, you may now set the required direction function of the four control
channels (NOR = regular function direction; REV = reverse function direction).
GAUI
AILE NOR
ELEV NOR
THRO REV
RUDD NOR
If you use a transmitter from a manufacturer not listed, you need to determine the required direction functions in practical
tests (see page P.13 to P.15).
3. Setting options at the 3-axis gyro system „GU-344 GYRO"
The 3-axis gyro system „GU-344 GYRO" can be set with a setting controller and DIP switches or by remote control.
a) Setting the „GU-344 GYRO" Manually
If the plug with the green connection cable is not connected to the receiver, the setting controller „A" and the DIP switch „1"
at the „GU-344 GYRO" are active.
• Turn the setting controller „A" from the left stop (minimum = position 4:30 hours) to the right by 90° to get the basic
setting (position 7:30 hours) of the gyro sensitivity for the first test flights. Use a suitable mini screwdriver for this. The
further the dial is turned to the right, the higher the stabilising effect of the 3-axis gyro.
The 3-axis gyro system „GU-344 GYRO" also has 2 different flight settings that can be selected with the DIP switch „1".
• If the DIP switch „1" is switched to the upper position „CRU" with the mini screwdriver, the control LED lights up red and
the quadrocopter behaves like a regular model helicopter. This setting is recommended for experienced model helicopter
pilots.
• If the DIP switch „1" is switched to the lower position „HOV" with the mini screwdriver, the control LED lights up green and
the quadrocopter is suitable for beginners learning hover flight. In this setting, the 3-axis gyro system receives the control
signals of the transmitter slightly and an exponential share is mixed in (see charts in the middle of page P.12). This permits
finer control of the quadrocopter in hover flight.
Use the DIP switch „2" to set two different flight alignments of the quadrocopter.
• If the DIP switch „2" is switched to the upper position, the X-flight alignment is activated. The centre between the motor
boom arms 1 and 4 is at the front in flight direction.
• If the DIP switch „2" is switched to the lower position, the cross flight alignment is activated.
Attention, important!
Since the Quadrocopter „500X-S" is only intended for the X-flight alignment, the DIP switch „2" always has to be
in the upper position and must not be switched (also see page P.16).
34
Futaba JR
NOR REV
NOR REV
REV NOR
NOR REV
Hitech
NOR
REV
NOR
NOR