Petromax Atago Bedienungsanleitung Seite 7

Figure 1
these steps to put the Petromax Atago into
service.
1. Use your fingers to grasp the handle in the
centre.
2. Pull the handle upwards to extend the inner
cylinder and the legs (see figure 2). Do not
use excessive force.
3. Carefully place the Petromax Atago on an
even, flat, solid and heat resistant surface.
Figure 2
PreParation & using the
Petromax atago
Do not use more than 30 charcoal
briquettes. Do not use charcoal
lighter fluid.
In no time, the Petromax Atago is ready for
cooking and barbecue purposes. Do not use
charcoal lighter fluid or another fluid for that
purpose. Only use solid fuel. Solid fuels (and
Petromax Zunder) are an excellent choice for
burning charcoal briquettes as the Petromax
Atago's high performance is caused by the
chimney effect. Read and follow these instruc-
tions to start the Atago and burn the charcoal
briquettes in the most efficient way.
1. Place the necessary amount of Petromax
Zunder (or another solid fuel) on the bottom
of the Petromax Atago. Spread it out evenly
on the bottom. You will need approximately
1 package of Petromax Zunder for 25 char-
coal briquettes.
2. Use the air regulation lever to allow
maximum air flow.
3. Place the charcoal grate in the Petromax
Atago.
4. Use charcoal tongs to place and position the
charcoal briquettes (use not more than 30
briquettes at once) on the charcoal grate.
Spread out the charcoal briquettes evenly to
allow a clean and consistent burn of char-
coal briquettes.
5. Light the Petromax Zunder (or any other
commercially available solid fuel for that
purpose).
6. Wait until the charcoal briquettes have a
red centre and are covered with grey ash.
7