Mounting And Alignment; Preparing For Assembly; Required Tools; Mounting - Powerfix KAA 31 A1 Bedienungsanleitung

Mounting and alignment

Preparing for assembly

DANGER
► Ensure that are no concealed electrical cables, water or gas pipes,
or other lines behind the mounting point on the wall or ceiling.
CAUTION!
► Select a mounting point inside or in a protected outdoor location.
The device is splashproof.
► Note that the supplied wall plugs
and brick walls. If you are unsure about the suitability of your wall or
ceiling, please consult an expert.
To align the device according to your needs, check that the camera hous-
ing can move around 90° vertically and 360° horizontally before
mounting. Select a mounting point that is clearly visible and thus well
suited for a dummy surveillance system.

Required tools

Mounting

♦ Hold the device's mounting foot
♦ Mark the drill holes in the four fixing holes
♦ Drill holes using an electric drill and a Ø 6 mm drill bit to a depth of
at least 30 mm at the marked positions.
♦ Insert the supplied wall plugs
♦ Screw the device to the wall using the supplied screws
KAA 31 A1
Pencil
Drill
Drill bit Ø 6 mm
Phillips screwdriver
are only suitable for concrete
at the desired mounting point.
in the mounting foot
into the holes.
.
.
│
GB 7 ■