Adjusting The Volume; Changing Dab Stations; Scanning For Dab Stations - Konig Electronic HAV-TR900 Serie Bedienungsanleitung

Using your DAB+ radio
Switching on for the first time
To switch on, turn the on/off & volume
control to the right. Press the DAB select
button. When DAB mode is selected for the
first time, the DISPLAY will illuminate and
'Welcome to DAB' will be displayed.
The DAB+ digital radio will automatically
begin to scan for stations. The screen shown
below is displayed. A bar graph indicates the
progress of the search.
Progress bar Signal strength symbol
When the scan is complete, the DAB+ digital
radio will select the first available station -
stations are listed in numerical then
alphabetical order.
The station list is retained in memory so the
next time you switch the DAB+ digital radio
on, the station search does not take place.
If there are no stations found, check that
adequate DAB coverage exists in your area.
It is possible to perform a manual scan for
stations, see Manual Tune on page 16.

Changing DAB stations

Press the ► and ◄ buttons to scroll up and
down the list of available stations. The
station names will appear on line 3 of the
display.
When the desired station is displayed, press
SELECT. The DAB+ digital radio will tune to
that station.

Adjusting the volume

To increase the volume, turn the volume
control to the right.
To decrease the volume, tum the volume
control to the left.
Tone dial
The tone dial is used to alter the audio output
of the DAB+ digital radio between a high
(treble) and low (bass) frequency range.
Turn the tuning control right to enhance the
high frequency (treble) content of the sound
output.

Turn the tuning control left to enhance the
low frequency (bass) content of the sound
output.

Scanning for DAB stations

Due to the nature of DAB radio, additional
stations and services regularly become
available. If you wish to see if there have been
any new DAB stations introduced in your area
you can initiate a search.
Press the AUTO button to activate a local
search for stations.
The DAB+ digital radio will automatically
begin to scan for stations. The screen shown
below is displayed. A bar graph indicates the
progress of the search and the number of
stations found as the scan progresses.
Progress bar
5
Number of
stations found