B) Hazer Operation; C) Soap Bubble Operation - Renkforce LV-BH 400 Bedienungsanleitung

b) Hazer Operation

Manual Operation:
• Press the green MANUAL FOG button on the remote control.
• The device emits fog as long as you keep this button pressed.
Continuous operation:
• Press the red CONTINOUS FOG button on the remote control.
• The device emits fog permanently and the red indicator LED is lit.
• Set the desired fog quantity using the OUTPUT controller.
• To deactivate permanent operation, push the red CONTINUOUS FOG button on the remote control
again.
Interval Mode:
• Press the yellow TIMER ON/OFF button on the remote control.
• The device now emits fog time-controlledly and the yellow indicator LED is lit.
• Set the desired pause duration between fog emissions using the INTERVAL controller.
• Set the duration of the fog emissions with the DURATION controller.
• Depending on setting of the controllers INTERVAL and DURATION, the device emits fog and then pauses.
Then the described interval starts over.
• To deactivate interval operation, push the yellow TIMER ON/OFF button on the remote control again.

c) Soap Bubble Operation

• Push the activation protection bracket at the radio remote control down to expose the operating but-
tons.
• Pull the telescopic aerial of the remote control out completely.
• Push this button ON to start soap bubble production.
• Push this button OFF to start soap bubble production.
• To empty the tank for the soap bubble fluid after operation, put a collection vessel below the drain socket
TAP (5) at the rear of the device and open the closure plug. Let the entire soap bubble fluid drain from the
machine and close the drain socket TAP (5) again.
Slightly tip the device backwards for easier draining of the soap bubble fluid.
28