Basic Operation; Connecting To Camera And Inserting Memory Card - Nikon MV-1 Bedienungsanleitung

Basic operation

1. Connecting to camera and inserting memory card

(Illustrations show the F6)
8
1
Confirm film is not loaded in the camera (E is
displayed in the frame counter) and battery
power is sufficient.
• If shooting data stored in the camera is too large
and/or data remains in the memory card, data
transfer from the camera to the memory card will
take a long time. Change batteries for new ones
when necessary.
x See camera's instruction manual for battery
power confirmation.
2
Turn the camera power off.
3
Remove the cap on the 10-pin terminal, insert
the MV-1 plug so that the Y mark on the plug
aligns with the index mark • on the camera
terminal, then rotate in the direction shown to
lock it in place.
• The position of the 10-pin terminal may vary
depending on your camera model. Refer to your
camera's instruction manual for details.
• The Extension Cord MC-21 cannot be used.
4
Insert the memory card into the memory card
slot.
• Supplied memory card has been formatted in FAT
file system (x
• Hold the memory card so that the label is on the
same side as the MV-1 start button, and insert it
pins-first into the memory card slot.
• Use a memory card in which no data remains.
• Refer to the list of supported memory card types
on p. 24 for more information.
13) and can be used as it is.