Operation; You Will Need; Installation Precautions - DAITEM DP1101 Bedienungsanleitung

GB

Operation

I The motion detector constantly monitors the interior of the home. It
detects the infrared radiation naturally emitted by the body of the intruder
moving around in the protected area. The area protected by this detector is
limited by the walls of the room in which it is installed.
Characteristics
G Dual Frequency radio transmission
G Programming by 2 specific keys:
- of the installation radio code
- of the zone and sensitivity
G 24 beams, 12 meters range with an angle of 75-90°
G Allocation:
- to zone 1: immediate triggering
- to zone 2: immediate or delayed triggering
- to zone 3: immediate triggering
- to zone 4: immediate or delayed triggering
G Test key with light indicator to check:
- the protected area
- the chosen zone
- programming
- radio link
- battery state
G 24 hour tamper protection against lid removal
G round-the-clock tamper-proof function
G Supplied by 3.6 V lithium battery (supplied)

Installation precautions

I Install it:
inside the home,
G
G high up (approx. 2.20 meters),
G so that the protected area does not overlap that of another motion detector,
It is recommended to protect the access to the control panel with a motion
detector (see fig. I).
G in high risk areas (lounge, main bedroom, etc.),
G perpendicular to the entrances to be protected (see fig. I).
I Do not install it:
G opposite or above a surface that can heat up quickly (electric convector,
fireplace, ventilator),
G opposite a bay window,
G directly on a metal surface,
G directed towards the outside of the home,
14
G where there is an obstacle (furniture, wall, pillar,...), which might prevent
detection, between the detector and the area to be protected.

You will need

G A cruciform screwdriver
G A drill with 6 mm Ø concrete bit
The battery (supplied)
G
G The fixing accessories supplied: 1 ball and socket joint, 1 long screw,
1 dowel, 1 washer.
Implementation
FIG. A
Front view
➀ ➁
Detection lens. Test button.
FIG. B
Opening
Open the detector casing by pushing the locking pin
driver.
FIG. D
Power supply
Connect the battery.
FIG. D E
and Detector coding
The detector is coded by programming using the programming indicator
light and keys 0 and 1.
Caution: do not press the test key while programming.
Programme first your installation radio code and then the zone assigned to
the detector and the detection sensitivity by pressing keys 0 and 1 in turn.
G Programming the installation radio code (fig. D)
You should code the control panel before the detector.
When you take the detector out of its packing, the installation radio code
correspond to the ten microswitches of the control panel all in ON position.
GB
➂
with a flat screw-
15