Cleaning And Maintenance; Disposal And Recycling - EINHELL 41.341.00 Originalbetriebsanleitung

Filterdruckminderer_SPK7:_
GB
pushed down again. The thread connectors on the
front and rear sides are for the attachment of pres-
sure gauges. Depending on installation, the connec-
tion opposite must be sealed with a dummy plug.
The scale classification of the pressure gauge
should lie above the value of the ultimate pressure.
If water builds up in the window, this should be
drained through the drain screw (5, for R 3/8" no pic-
ture).

8. Cleaning and Maintenance

8.1 Cleaning
Keep the appliance as dust and dirt-free as pos-
sible. Wipe the appliance with a clean cloth or
blast it with compressed air at low pressure.
We recommend cleaning the appliance immedi-
ately after every use.
Clean the appliance regularly with a damp cloth
and some soft soap, or with detergent. Do not
use cleaning agents or solvents. These may be
aggressive to the plastic parts in the appliance.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
Dirty oil and oil-water mixtures should be handed in
to an appropriate collection point.
8.3 Ordering replacement parts
Please quote the following data when ordering repla-
cement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as spe-
cial waste. Ask your dealer or your local council.
6
13.05.2009 13:54 Uhr Seite 6