EINHELL 41.341.00 Originalbetriebsanleitung Seite 5

Filterdruckminderer_SPK7:_
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at
all times. If you give the equipment to any other per-
son, hand over these operating instructions and
safety regulations as well. We cannot accept any lia-
bility for damage or accidents which arise due to a
failure to follow these instructions and the safety
instructions.
1. Safety instructions
1.1 Safety instructions for working with
compressed air and blasting guns
Compressors and lines reach high temperatures
during operation. Avoid contact! Risk of burns!
Gases or vapours drawn in by the compressor
have to be kept free of constituents that may
cause fire or explosions inside the compressor.
When you disconnect the hose coupling, hold
the coupling element in your hand to prevent
injury from the whiplashing hose.
Wear goggles when working with the blow-out
gun. Injuries may easily result from foreign
bodies and blasted parts.
Never point the blow-out gun at other persons
and never use it to clean clothes that are still
being worn.
Keep these safety instructions in a safe place.
2. Layout
1 Control knob
2 Pressure gauges
3 Quick-lock coupling
4 Oil level window
5 Drain screw (for R 3/8" no picture)
3. Items supplied (Fig 1/2)
Take all parts out of the packaging and check that
they are complete.
Filter pressure reducer R 1/4" (Figure 1)
Filter pressure reducer R 3/8" (Figure 2)
Threaded nipple (6) and quick-lock coupling(3)
Original operating instructions
13.05.2009 13:54 Uhr Seite 5
4. Intended use
Designed to reduce pressure of compressed air (inlet
pressure up to max. 10 bar).
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufactur-
er will be liable for any damage or injuries of any
kind caused as a result of this.
5. Technical data
Inlet pressure
Adjustable pressure range
6. Assembly
Appliance should be connected in the direction of the
arrow at the compressor outflow. It is also possible to
affix the appliance to the wall with the wall mount.
Connect
Push the nipple on your compressed air hose into
the quick-release coupling, the sleeve will automati-
cally spring forwards.
Disconnect
Pull back the sleeve and remove the hose.
Important. As you release the hose coupling,
hold the hose coupling part in your hand to pre-
vent injuries caused by the hose being thrown
backwards.
The compressed air hose is also fitted with a quick-
lock coupling to which accessories can be connected
as described above.
7. Settings and operation
Close all outputs (Compressor is in operation). Now
pull the control knob (1) on all types. Turn the knob
to the right until the pressure gauge shows the
desired pressure.
After adjusting the pressure, the control knob will be
GB
max.10 bar
up to 8 bar
5