Cleaning And Care; Emptying The Fl Uff Collector; Cleaning The Housing And Cutting Head - Aquapur AFR 3 C2 Bedienungsanleitung

Cleaning and care

Emptying the fl uff collector
1) First pull the fl uff collector 3 a little way down
and lift it off .
2) Empty out the textile fl uff .
3) Replace the fl uff collector 3 so that it is fi rmly in
place.

Cleaning the housing and cutting head

ATTENTION! MATERIAL DAMAGE!
Do not use abrasive, aggressive or chemical cleaning
agents. These could damage the surface of the
appliance!
Clean the housing, the removed spacer 5 and the
♦
protective cap 6 with a moist cloth.
Unscrew the shaver foil 4 from the appliance.
♦
Clean the shaver foil 4 with a slightly damp cloth.
WARNING! RISK OF INJURY!
Be careful when handling the blades under the
shaver foil 4. These are very sharp and can easily
be damaged.
♦ Brush fl uff and lint remnants from the cutter knives
with the cleaning brush 7.
When all parts are well dried, screw the shaver foil 4
♦
back on.
Replace the spacer 5 so that it is seated fi rmly.
♦
AFR 3 C2
│
GB
23 ■