Programming The Alarm; Operation - WeTek 85 58 67 Bedienungsanleitung

Programming the Alarm

1. To set or change the security code of the remote control,
simply set the programmable switches (12) to the desired
code and remove the batteries from the alarm unit. Then
wait at least 30 seconds for the alarm to reset.
2. Immediately after inserting the batteries point the remote
control at the alarm and press the "ARM" button, the
Alarm LED (4) will flash once to indicate that it has learnt
the code of the remote control.

Operation

When exiting from the protected Area
Point the remote control at the alarm unit and press the
"ARM" button. A confirmation tone will indicate that the
alarm is armed and you have 30 seconds in which to vacate
the area. After this time, if motion is detected then the alarm
will sound.
When entering the protected Area
Simply point the remote control at the alarm unit and press
the "DISARM" button. Please note that on entering the area,
there is a short beep to indicate that motion has been
detected and after a 4 second delay the alarm will sound.
During this time the Alarm can be silently disarmed. The
alarm sound can be turned off anytime by pressing the
"DISARM" button on the remote.
Detection Range
The motion detector of the alarm unit has a detection range
of 360º.
Installation and Operation
9