Basic Functions - MBL 1621 A Bedienungsanleitung

4. Basic Functions

a
Turning on the Power and Inserting a CD
If you have properly connected the transport to the D/A-Converter and to the wall outlet,
turn the power on with the power switch. The power switch on the mbl 1621 A is located
on the left side of the rear panel.
The display will now flash for a few seconds. If no CD is in the transport, the signal "no
disc" will appear on the display.
To insert a CD open the lid of the transport. The display will now show the word "open".
Now insert the CD into the transport with its printed surface upwards. The shiny surface,
on which the actual data is stored, must face downwards. Then put on the stabilizer and
close the lid. Note that you cannot play a CD without the stabilizer.
The display will now flash for a few seconds, and then it will show the number of tracks
and the total playing time of the CD.
The CD transport is now ready for playback.
b Playing a CD
Press the play button to start playback. After a few seconds, the display will show the
number of the track that is playing, the triangular symbol for playback and the elapsed
playing time of the track.
The transport counts minutes and seconds upwards, beginning with 0:00 of each track.
If you have properly connected the mbl 1621 A CD transport to the other components
of your home stereo system, you will now hear the music. If not, please refer to our
troubleshooting section.
If you press the play button during playback, the current track will restart at the begin-
ning (0:00).
c
Pause Playback
If you intend to interrupt your listening pleasure for a moment, but want to carry on
from the same position, press the pause button: The time counter stops, and the display
shows "pause".
To resume playback from the same position, press the pause button again. The transport
returns to the playback mode.
mbl 1621 A
9
unique high end audio
display flashes
no disc inserted
lid open
TRACK TOTAL TIME
CD DATA
TRACK TIME
play
TRACK TIME
play pressed twice
TRACK TIME
pause