Additional Accessories; Positioning The Device And Commissioning - Wisd MSH-20D Bedienungsanleitung

www.witeg.de

4.2 Additional accessories

order number
DH.WHP503020
DH.WHP503021
DH.WHP503011
DH.WHP503012
DH.WHP503030
DH.WHP503031
DH.WHP503036

5 Positioning the device and commissioning

1. Follow especially the safety instructions marked with following symbol:
2. Remove the package carefully.
3. If there are any unexpected transport damages, please inform your forwarder and your
customer service.
4. If you want to use the device without additional accessories jump to point 10 (next page),
otherwise follow the next points.
5. Attach the stand rod to the socked.
6. Fix the clamp at the stand rod.
7. Attach the sensor holder to the clamp. Have a look at the next picture if you are unsure.
Ensure that the bigger drill hole is upside.
8. Stick the sensor into the holder and connect the cable with the device's sensor socked
backwards.
9. Check that each connection fits close.
10. Before you connect the device with the electrical outlet, please let some time laps until
the device is acclimatised.
11. Make sure that you follow all safety instructions.
12. Connect the device with the power outlet.
13. Switch the device on.
14. Set your values and start the process (look at job description).
witeg Labortechnik GmbH, WiseStir
Temperature sensor PT100 for MSH-30D
Teflon-coated temperature sensor PT100 for MSH-30D
Stainless steel stand rod,  12,7mm, length 390 mm for MSH-30D
Holder for temperature sensor + clamp
for MSH-20D/ -30D/ -50D/ -55D
Temperature sensor PT100
for MSH-20D/ -50D/ -55D
Teflon -coated temperature sensor PT100
for MSH-20D/ -50D/ -55D
Stainless steel stand rod,  10mm, length 450 mm
for MSH-20D/ -50D/ -55D
®
MSH-D Hotplate Magnetic Stirrer
17
denomination