Herunterladen Inhalt Inhalt Diese Seite drucken

Installing And Operating Your Freezer; Before Using Your Freezer - Nordmende RUF147WHA+ Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• When taking ice made in the freezer department, do not touch it, ice
may cause ice burns and/or cuts.
• Do not touch frozen goods with wet hands! Do not eat ice-cream and
ice cubes immediately after you take them out of the freezer department!
• Do not re-freeze the frozen goods after being melted. This may cause health issues
like food poisoning.
• Do not cover the body or top of freezer with lace. This affects the performance of your
freezer.
• Fix the accessories in the freezer during transportation to prevent damage to
accessories.

Installing and operating your freezer

Before starting to use your freezer, you should pay attention to the following points:
• Operating voltage for your freezer is 220-240 V at 50Hz.
• W e do not take the responsibility of the damages that occur due to ungrounded
usage.
• Place your freezer in a place that it would not be exposed to direct sunlight.
• Your appliance should be at least 50 cm away from stoves, Gas
ovens and heater cores, and should be at least 5 cm away from
electrical ovens.
• Your freezer should never be used outdoors or left under the rain.
• When your freezer is placed next to a deep freezer, there should be
at least 2 cm between them to prevent humidity on the outer surface.
• Do not place anything on your freezer, and install your freezer in a
suitable place so that at least 15 cm is available on the upper side.
• The adjustable front legs should stabilized in an appropriate height to allow your
freezer operate in a stable and proper way. You can adjust the legs by turning them
clockwise (or in the opposite direction). This should be done before placing food in
the freezer.
• Before using your freezer, wipe all parts with warm water added with a tea spoonful
of sodium bicarbonate, and then rinse with clean water and dry. Place all parts after
cleaning.
• Install the distance adjustment plastic (the part with black vanes at
the rear) by turning it 90° as shown in the figure to prevent the
condenser from touching the wall.

Before using your freezer

• When it is operated for the first time or after transportation, keep
your freezer in the upright position for 3 hours and plug it on to
allow efficient operation. Otherwise, you may damage the
compressor.
• Your freezer may have a smell when it is operated for the first time; the smell will fade
away when your freezer starts to cool.
EN - 5 -

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis