Safety Instructions - Phottix Indra500 TTL Benutzerhandbuch

Thank you for purchasing a
Note: Before using the Phottix Indra500 TTL Studio Light, please read this in-
struction manual carefully.
The Phottix Indra500 TTL is a battery and AC powered portable studio light with
a built-in radio and optical pulse wireless receiving function. It offers TTL, Manu-
al and Multi Stroboscopic modes, as well as high speed sync and second curtain
sync functions. The Phottix Indra500 TTL Studio Light is compatible with many
existing Phottix products.

Safety instructions

The Indra500 contains high voltage electronic parts. Do not disassem-
●
ble or attempt to repair the Indra500. Keep this product out of the reach
of children.
● Never use this product near combustible gases, solvents or in an envi-
ronment with a high electrical charge.
Make sure all plugs and cables are well connected during charging
●
and use.
Disconnect the Indra500 TTL Studio light from a power source for 10
●
minutes before changing the flash tube. Use caution, the flash tube can
get very hot.
Do not touch the external power port and ensure it does not have con-
●
tact with any metal objects – this could cause electric shocks and serious
injury.
● The external power source should not exceed the technical specifica-
tions in this manual.
The external power should be used in an environment with good ven-
●
tilation. Do not use this product in dusty or sandy conditions.
This product is not waterproof. Keep it away from rain, snow and high
●
humidity conditions.
Do not clean the product with organic solvent or alcohol-based liquid.
●
Do not put opaque objects in front of the studio flash head when firing
●
the studio light. The heat energy emitted by the Indra500 may cause ob-
jects to burn, or cause damage to the studio flash tube.
Use your studio light safely. Do not fire the Indra500 into the eyes of
●
people or animals at short distances this may cause damage to the eyes
and/or blindness.
Do not leave the studio light in a hot location (direct sunlight, in a
●
closed car, etc.).
Should you notice smoke or an unusual smell coming from this prod-
●
uct, immediately turn off the power switch on the studio light.
Turn off the power switch on the studio light when not being used for
●
an extended period of time.
Remove the front cover before operating the studio light. Otherwise,
●
the front cover will get deformed or cause a fire due to the high temper-
ature of the studio light.
Use caution in touching the studio flash head after use. It may still be
●
hot and could cause burns.
Consult local authorities on the proper disposal or recycling of a Phot-
●
tix Indra500 TTL Studio Light.
2
Phottix product
INSTRUCTION MANUAL
En
Table of Content
Parts and Functions ................................................................... 2
Flash Modes ............................................................................... 8
Wireless Receiving Modes ........................................................... 9
Custom Functions ..................................................................... 12
Technical Specs ......................................................................... 13
Parts
Full View
1. Front Cover
2. Umbrella Holder
3. Quick-Release
Locking Latch
4. Handle
5. 3.5mm Sync Port
6. USB Output Port
7. External Power Port
8. Angle Adjustment
Ratchet Handle
9. Mounting Column
10. Clamp Screw
Back View
11. LCD Display
12. Function Button 1
13. Function Button 2
14. Test/Ready Button
15. Adjust/Set Knob
16. Power Switch
17. Modeling Light Switch
18. Function Button 3
19. Function Button 4
20. Optical Signal Sensor
Front View
21. Mounting Slot
22. Glass Dome
23. LED Modeling Light
24. Flash Tube
25. Reflector