Resetting To Factory Defaults; Technical Specification - Phottix Indra500 TTL Benutzerhandbuch

Resetting to Factory Defaults

The Indra500 TTL Studio Light can be reset to factory defaults.
Press and hold both Function button 1 and the "Adjust/Set knob" for 3 seconds.
This will reset all function settings to factory defaults.
Checking the Studio Light Information
Pressing the combination keys can check the Phottix Indra500 TTL Studio Light
information: Hardware, software, icon library, and product serial number.
1. Press and hold Function button 2 and "Adjust/Set Knob" for 3 seconds. The
information display screen will show the hardware, software, icon library, and
product serial number.
2. Press any button to exit the information display screen and return back to the
standard screen.
3. Triggering the studio light or camera focusing, or taking photos when the stu-
dio light is displaying the version information will cause the studio light to exit
the version display screen and return back to the standard screen.
Changes to the Studio Light Capacitor
If the Indra500 is not used for some time physical changes will take place within
the flash's capacitor. Make sure to turn on the flash for a minimum of 10 minutes
every three months to prevent any changes.
13
INSTRUCTION MANUAL
En

Technical Specification

Max power: 500Ws
Adjustable power stops: 8 Stops (4-500Ws)
Power adjustment: In 1/3stop or full stop increment
Flash modes: TTL Auto, Manual (M), Multi
Light angle: 60°
Guide Number: 45/147.6 (ISO100, m/ft)
Color temperature: 5600±200K (Color temperature may vary at low power
settings)
Flash duration time: t=1
1/250s - 1/12000s
Stroboscopic flash: Frequency: 1-100Hz, Flash Count: 1-100 times
HSS&SCS: Support*
Recycling time(at 1/1 flash power levels; the indicator will light red)
Phottix Indra AC Adapter: Single/Two flashes: 0.9s/1.7s
Phottix Indra Battery Pack (10AH): H mode Single/Two flashes: 1s/2.3s
Phottix Indra Battery Pack (5AH) H mode Single/Two flashes: 1.4s/4.9s
Input power:
Phottix Indra AC Adapter: AC 220V/110V, 50HZ/60HZ
Phottix Indra Battery Pack: 14.8V/5Ah, 400 full power flashes
14.8V/10Ah, 800 full power flashes
Modeling Light Power: about 4.5W
Modeling Light Modes: OFF, Manual 1-9 levels
Wireless connectivity method: Radio Frequency and Optical pulse
Channel: 4
Wireless receiving modes: Odin-C, Odin-N, Strato II, Opt-Slave, RX OFF (Can
only be fired via 3.5mm sync port)
Receiving range (Approx.): Radio: 100m+
Display: 320X240 TFT LCD display, Support 3 color screen settings
LCD Display Senor Setting: Sense direction automatically and make a
180-degree turn according to the direction
Heat Dissipation Method: Automatically turn on according to the temperature
Recycle confirm: Can be enabled or disabled
Sync Port: 3.5mm mini port
Firmware Upgrade: Upgrade of firmware is made via the USB mini port
Dimension: Length*Diameter: 266mm*180mm
Weight: 2.1kg (Excluding the Studio Light Power Cable)
Please note: Product specifications and external design are subject to change
without further notice.
*On compatible cameras
S mode Single/Two flashes: 1.4s/5.4s
S mode Single/Two flashes: 2.6s/10.9s