PeakTech 5201 Bedienungsanleitung Seite 18

5. Operating Instruction
Turn the Meter ON by pressing the button "ON", then press the
MEAS button to start measuring. User press MEAS button for the
first time when the meter turned on, please hold the meter up so
that the ball sensor is in the air and not covered by your hand, any
surface or object for 8 to 10 cm distance. The LCD will display
"CAL" indication and then moisture value will be displayed in LCD.
The value must below 0,5. If not, please turn the meter on over
again and repeat hereinbefore operation. Then the meter start to
measuring the object. Press the MEAS button again, the moisture
measurement shall latch on the display for 30 sec. HOLD symbol
will displayed. After 30 sec. the meter will turns off automatically.
Note:
When you turn meter on once, you must calibrate once and if you
move from one place to another place, you must calibrate the
sensor again.
-17-