Matrix BMS 1400-3 Originalbetriebsanleitung Seite 27

Assembly of Line Cassette
To avoid the risk of an unwanted engine start, pull
out the spark plug.
RISK OF INJURIES
CAUTION: Always wear protective
gloves when working with and around
cutting tools.
The petrol cutting blade is supplied with attached
cutting blade (11) and associated guard (12).
To use the petrol cutting blade as grass trimmer,
proper guard (12) and line spool (13) must be
attached.
- Use a screwdriver, or the supplied Allen key (14)
to fix the shaft of the petrol brush cutter at the
intended location (B6) by a locknut.
- Use the supplied hexagon wrench (15) to loosen
the hexagonal screw for attachment of the
cutting blade (B7) by turning it in clockwise
direction.
- Remove the hexagonal screw, the lock washer,
and the retaining disk for the cutting blade (B8).
Keep these parts at a safe location.
- Attach the locking part (B9).
- Use a screwdriver, or the supplied Allen key to
fix the shaft of the petrol cutting blade
at the intended location by a locknut (B10).
- Now screw the line cassette (13) onto the shaft
in a counter-clockwise direction (B10).
CAUTION: Left-handed Thread
Assembly of Cutting Blade
To avoid the risk of an unwanted engine start,
pull out the spark plug socket.
RISK OF INJURIES
CAUTION: Always wear protective
gloves when working with and
around cutting tools.
The cutting blade must be sharpened periodically
according to instructions. Improperly sharpened
or blunt cutting edges may cause the tool to
overload.
RISK OF RUPTURES and CRACKS
Fragments hurled away from the cutting tool can
cause extremely severe injuries.
To use the petrol cutting blade as an
engine powered trimmer, the proper guard
and cutting blade must be attached.
- Use a screwdriver, or the supplied Allen key to
fix the shaft of the petrol cutting blade
at the intended location by a locknut. Now
remove the line cassette (13) from the shaft by
turning it in clockwise direction (B11).
- Place the cutting blade (12) on the locking part.
- Place the retaining disk (observe side) and the
lock washer on the cutting blade (11) (B13).
- Use a screwdriver, or the supplied Allen key to
fix the shaft of the petrol cutting blade
at the intended location by a locknut. Screw the
hexagonal screw on the shaft in anti-clockwise
direction, and use the supplied hexagonal
wrench (15) to tighten this screw (B14).
CAUTION: Left-handed Thread
Assembly of Carrying Strap
The petrol cutting blade must be used with a
carrying strap (17).
First, balance the petrol brush cutter
when the tool is swithced off.
27