Deleting The User Code - salvus PS300 Bedienungsanleitung

2.3 Changing the user code (by a user, without the master code.)
Please note – the user code may not be the same as the master code!
Make sure that the safe door is open when you change the code (ON – user code – ENTER).
Step
1. Press ON
2. Press Enter
3. Press 3
4. Press Enter
5. Enter the new user code, e.g. 111111
6. Press Enter
7. Enter the new user code, e.g. 222222
8. Press Enter
9. Repeat the new code, e.g. 222222
10. Press Enter
The new user code is now set. If the new code is not accepted, you hear a long signal and a red light flashes.
In that case, start again at step 1 for changing the user code.
After changing the code, it is best to test the new code several times with the door open.

2.4 Deleting the user code

Only with the master code can a user code deleted.
Step
1. Press ON
2. Press Enter
3. Press 0
4. Press Enter
5. Enter the master code, e.g. 567891
6. Press Enter
Only the master code remains valid. If the user code deletion is unsuccessful, you hear a long signal and a red
light flashes. In that case, start again at step 1 for deleting the user code.
You can only program opening delay and window times by using the master code. Make sure that the safe
door is open when you start programming an opening delay and window (ON – master code – ENTER).
Action
Action
Key Signal
ON
Enter
3
Enter
111111
Enter
222222
Enter
222222
Enter
Key Signal
ON
Enter
0
Enter
567891
Enter
23 15