After-Sales Service; Product Features; Installation Instruction - SCAN domestic RKB 200 Bedienungsanleitung

AFTER SALES SERVICE
Before calling your local authorized agent if the refrigerator is not
working check that the plug is properly inserted into the electric
socket and that the thermostat is not set on position "0"; if the
refrigerator is abnormally noisy, make sure it is perfectly leveled
and that no external object is touching the back panel of the ap-
pliance; if the refrigerator does not produce enough cold, check
that it has not been over loaded, that the door closes properly
and that the condenser is not full of dust If you should notice an
excess amount of water in the lower part of the refrigerator |
(vegetable box and removable shelf), | check that the drain hole
for defrost water is not clogged.
The buyer is responsible for damages caused by faulty instal-
lation, and not responsibility can be accepted if the appliance
is not earthed in accordance with the national standards rules
presently in force.
At the end of the functional life of the equipment which
uses cooling gas R600a (isobutane) and inflammable gas
inside the insulating foam, it must be placed in safety before
sending it to the waste disposal. For this operation contact your
dealer and the local authorities.
WARNING: Do not damage the refrigerant circuit

Product Features

Main parts
1. Freezer drawer
2. Thermostat
3. Refergerator shelf
4. Fruit and vegetable salad drawer
5. Compressor
6. Adjustable feet
7. Dairy and muliti-purpose Guard
The above illustration diagram may be different of the product.
All the detail is respected to the accurate product only.

Installation Instruction:

1 The appliance cannot tilt more than 45 degrees when you
move it.
Do not put force on any part as the condenser, the door and
handle. It will be deformed surfaces or disrupt the operation
of the refrigerator.
2 Make sure there is enough space around refrigerator. It will
help for the applaince for ventiliation
3 The appliance should be keep away from any heat source
and sunshine.
4 This product complies with directives 2006/95/EC (LVD) and
2004/108/EC (EMC)
5 For domestic and indoor use only. This product must be
installed according to national fittings standards
6 Product must be grounded. If the socket outlet or supply
mains don't have grounded connection, you must not con-
nect the appliance.
7 If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.
8 This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabili-
ties, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the
appliance by a person responsible for their safety,
Children should be supervised to ensure that they do not
play with the appliance.
9 CAUTION: In order to avoid a hazard due to inadvertent
resetting of the thermal cutout, this appliance must not be
supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on
and off by the utility
10 The plug must be accessible after the installation
11 WARNING: Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of obstruction.
12 WARNING: Do not use mechanical devices or other means to
accelerate the defrosting process, other than those recom-
mended by the manufacturer.
13 WARNING: Do not damage the refrigerant circuit.
14 WARNING: Do not use electrical appliances inside the food
storage compartments of the appliance, unless they are of
the type recommended by the manufacturer.
9