Canton C 500 Aktiv Bedienungsanleitung Seite 55

Configurating the input (INP)
When the device is supplied all the physically existing inputs are provided with a source designation� These are as follows: ARC = TV;
HD1 =BDP; HD2 = SAT; HD3 = PS; COX = DVD; OPT = CD; AUX = VCR; BT = Bluetooth
various inputs to suit your source device�
To configure the designation proceed with the following steps:
With the device switched on press and hold one of the two "Input" keys for
1
more than 3 seconds until
Now press one of the two "Input" keys briefly to select the desired physical
2
input (ARC, HD1, HD2, etc�)�
Now press one of the "Volume" keys briefly to select the desired designation�
3
You can choose from the following predefined designations:
"---" (Input deactivated), TV, BDP, SAT, CD, DVD, CAM, REC, PAD, POD, TAB,
TUN, DAB, PS, VCR�
To allocate a designation to an additional input, repeat steps 2 and 3�
4
Exit the menu by pressing and holding one of the two "Input" keys again for
5
more than 3 seconds� If no input is received within 10 seconds the device will
automatically leave the configuration menu�
Note: Inputs that have been deactivated "---" will no longer be shown when scrolling
through the inputs (input key)� This makes it easier to select the desired input�
Comment: The designation for the BT input cannot be changed� If you would have deactivated all inputs, BT (Bluetooth
will remain as fixed input�
appears on the display�
INP
� You can configure the names allocated to the
®
ON MUTE
STANDBY
English
TV remote control
)
®
3 5 5