Programming Overview - Novoferm T 100 DES Montage- Und Bedienungsanleitung

Programming Overview

3-9
Menu
No.
Entry
Selection
point
3 Setting the door's top end-of-travel position
30
Change of direction (press for 5 sec.)
31 Setting the door's bottom end-of-travel position
32 Setting the door's half-open position
50* Fine adjustment of top end-of-travel position
33 50 - 0 0... 80mm deeper
50 - 99 0... 80mm higher
50* Fine adjustment of bottom end-of-travel position
34 50 - 0 0... 80mm deeper
50 - 99 0... 80mm higher
Selecting the closing edge
0* Optical closing edge OSE
35
1 Electrical safety edge 8K2
2 Pressure wave edge DW with testing
Selecting the photocell
0* without photocell
36
1 2-wire photocell Ls2
2 4-wire photocell LS5, Reflection photocell
3 Frame fitted photocell LS2
4 Photocell LS5, frame fitted reflection photocell
25* Adjustment pre-limit switch safety edge
37 25 - 0 0... 50mm deeper
25 - 99 0... 100mm higher
- -
Exit menu
Selecting the operating modes
0 Dead man OPEN / Dead man CLOSE
4
1 Impulse OPEN / Dead man COSE
2* Impulse OPEN / Impulse CLOSE
40
3 AR - automatic closing
4 AR - shortened response time
5 Open-Close-operation/Red-green-traffic light A800 (option)
6 Like 5, but with a reduction at the light barrier
Response of safety edge
41 0* Full reversing
1 Partial reversing
Correcting the slowing-down path
42 0 off
1* on
Level adjustment
0* off
43
1 activated for 200 cycles
2
activated for 1,000 cycles
Menu
30-
37
* Factory defaults
Item
1x
Menu-
No.
Entry
Selection
point
4 Hold-open phase in seconds
0* 0
1 10
2 20
3 30
4 40
44
5 50
6 60
7 90
8 120
9 150
10 180
11 210
12 240
Status relay
0* Door closed signal
1 Door open signal
45 2 2 minutes garage light
3 5 minutes garage light
4 Hand transmitter on / off
5 Wipe impulse ELTACO
Status relay X6
0 Door closed signal
1* Door open signal
46
2 Red traffic light without early warning phase
3 Red traffic light with 3 seconds early warning phase
4 Red traffic light with 10 seconds early warning phase
Spring breakage detection
Display spring balance (press 5 sec.)
47
0* off
1 - 99 Input spring force
Opening force limit
0* off
48
1 - 98 Input cut-off force
99 Carry out weight measuring run with test weight
Motor starting time
0* Without limitation
1 D rive motor
2 D rive motor
49
3 D rive motor
4 D rive motor
5 D rive motor
6 D rive motor
- -
Exit menu
Enter
X5
5.24 25 min / 35 %
5.24 WS 25 min / 30 %
9.15, 9.20, 9.24 25 min / 60 %
9.24 WS 25 min / 20 %
6.65 10 min / 35 %
14.15 25 min / 60 %
GB
Exit