Useful Tips; Motor Block - RUSTA 900701310101 Gebrauchsanweisung

ENG
TURN ROTATION KNOB FROM "MIN" POSITION TO "MAX" POSITION)
4. You can set the speed of the high-performance motor between a min and max by
using the selector switch on the propulsion unit. To start, select the desired level.
Then press the start button
selector switch back to '0' setting.
ATTENTION! The blender will only be switched on if the glass jug is correctly fitted.
A safety shutdown prevents operation without the jug.
SPEED SETTING
Rotation knob in "ON" position + "interval" button
Rotation knob in "ON" position + "ice crush" button
Rotation knob in "ON" position + "smoothie" button
Rotation knob in the position from "MIN" to "MAX"
• It is recommended that, this product should not exceed 2 minutes in operation and
then allow it to cool down. Prevent motor from becoming too hot and tend to damage
the motor.
• After using the blender, to switch off, either press the stop button ☐ or turn the
selector switch back to '0' setting and pull out the mains plug.
• To remove the glass jug just turn it in anticlockwise direction to loose and lift it up.

USEFUL TIPS

• To achieve the best results when pureeing solid ingredients, place small portions into
the glass jug one by one instead of placing a large quantity all at once.
• If you are processing solid ingredients, cut them into small pieces (2–3 cm) first.
• When mixing solid ingredients start off first with a small amount of liquid. Gradually
add more and more liquid through the opening in the lid.
• Always place your hand on top of the blender when you are operating the device.
• Be careful when processing hot liquids.
• For stirring solid or very thick liquid ingredients we recommend that you use the
blender in "interval" mode to prevent the blades from becoming stuck.

MOTOR BLOCK

Never immerse the motor block in water. Wipe it only with a moist cloth.
SIMPLE CLEANING/ RINSING OUT THE ASSEMBLED GLASS JUG
Empty the glass jug and fill it with water. Place the glass jug on the motor block and allow
the motor to run for a few seconds or use the "interval" function. With a maximum of 1 litre
of fresh water and add a few drops of a washing-up liquid. Afterward, thoroughly rinse the
entire jar with fresh water.
6
▷
.To switch off, either press the stop button ☐ or turn the
USE
For cleaning
For ice crushing
For smoothies
F
or mixing liquids and solid foodstuffs