Selecting D24S In Multiple-Unit Systems - Yamaha RC-D24 Bedienungsanleitung

Selecting D24s in Multiple-Unit Systems

In a multiple-unit system, the RC-D24 can control the entire system through Chase
mode or individual D24s. To control the entire system through Chase mode, the Unit
Select function is set to the same ID as that assigned to the master D24. Individual D24s
can be controlled using the exclusive Remote ID number assigned to each D24. (See the
D24's Owner's Manual for more information on setting Remote IDs.) To control the
D24 assigned Remote ID 2, for example, the Unit Select function on the RC-D24 is set
to ID 2.
While holding down the [SET] button, press the [UNIT SELECT] button.
1
The current Unit Select setting flashes on the display, as shown below. The small circles
above the unit numbers indicate which D24s are available.
REMOTE CONTROLLER/LOCATOR
If a D24 doesn't appear to be available, make sure that it's connected correctly and
turned on. See page 7 for more information on connecting the RC-D24 and D24s.
Use keypad buttons [1] through [8] to select individual D24s.
2
Press the [ENTER] button to activate your selection, or the [CANCEL] button
3
to leave the Unit Select function.
The small circles above the unit numbers disappear and the previously shown informa-
tion reappears on the display.
Selecting D24s in Multiple-Unit Systems
H
0 0 0 0 0 0 0 0
ms
H
1
READY UNIT 1
Current Unit
Select setting
M S F
M S F ms
2 3 4 5 6 7 8
Available D24s
RC-D24—Owner's Manual
8