Cleaning And Maintenance - Ideen Welt MMF-234-V2 Bedienungsanleitung

7. To prepare cold milk froth, press the cold button
attachment (4) starts rotating.
8. To prepare hot milk froth, press the hot button
(4) starts rotating, and the milk is being heated.
9. After approx. 60 to 120 seconds, the milk foamer stops operating, and the cold button
hot button
10. Hold the milk container by its handle (7) and lift it from the base. Remove the cover, and then
pour the milk foam from the container.
11. Place the milk container on a heat-resistant surface or back on the base.
12. Disconnect the power plug and let the device cool down.
Heating milk
1. Lift the milk container (5) from the base (9) and remove the cover (1).
2. Install the attachment for heating milk (2) all the way on the rotating pin (12) inside the milk
container (5).
3. Fill the milk container (5) with up to 250ml of cold milk. Caution! Do not exceed or fall below the
MAX or MIN
4. Close the cover (1).
5. Connect the power plug (8) to a suitable power socket.
6. Put the milk container on the base (9).
7. Press the hot button
milk is being heated.
8. After approx. 60 to 120 seconds the milk foamer stops operating, and the hot button
flashes for 30 seconds before turning off.
9. Hold the milk container by its handle (7) and lift if from the base. Remove the cover and pour the
hot milk from the container.
10. Place the milk container on a heat-resistant surface or back on the base.
11. Disconnect the power plug and let the device cool down.

CLEANING AND MAINTENANCE

Caution! Always unplug the device and allow it to cool down before
cleaning.
Caution! Do not immerse the milk container, base or power cable with plug
into water or other liquids.
Attention! Do not use alcohol, acetone, benzene, aggressive cleaning
agents, etc., to clean the synthetic parts of the device. Do not use hard
brushes or metallic objects.
Please Note: The device and its accessories are not dishwasher proof.
Clean the device immediately after use, in order to prevent accumulation of milk residue.
1. Use a damp cloth and if necessary some mild detergent to clean the device surfaces.
2. Rinse the inside of the milk container (5) thoroughly with hot water and dishwashing
detergent. Use a soft sponge for removing residue, in order not to damage the anti-stick
properties of the container.
3. Rinse the cover (1) and attachments (2, 4) thoroughly with hot water and dishwashing
detergent. If needed, remove the silicone ring (3) and rinse it separately.
4. Rinse all parts with clean water.
5. Dry all parts.
P170011_R4G_MMF-234-V2_MilkFrother_6L_20170504.indd 13
(11) flashes for 30 seconds before turning off.
markings inside the milk container.
(11). The button lights up red, the attachment (2) starts rotating, and the
(10). The button lights up blue, and the
(11). The button lights up red, the attachment
13
(10) or
(11)
t
4/5/2017 2:46 PM