Available Versions; Hvi Conductor (Pre-Assembled) / Hvi Long Conductor - Dehn HVI Leitung HVI long-Leitung Montageanleitung

3. Available versions

3.1
HVI Conductor (pre-assembled) / HVI long Conductor
® ®
In general, one conductor end of the pre-assembled HVI Conductors is fitted with the relevant connec-
®
tion element as shown in Table 3, page 9 and Table 4, page 10. Thus, the head piece is fixed and a heat
shrinkable sleeve is wrapped around it. If required, the second conductor end can be shortened to
exactly match the loose connection element to the installation.
When ordering HVI Conductors, the conductor/minimum length must be observed/indicated. This in-
®
formation is binding. Conductors cannot be returned since they are tailored to customer needs (pre-as-
sembled conductor lengths). Pre-assembled HVI Conductors are available with a standard/minimum
®
length of 6 m and can be customised in 0.5 m steps. The standard/minimum length of 6 m must be used
in combination with a 3.2 m long supporting tube.
A loose connection element, heat shrinkable sleeve and hexagon socket wrench are included in deli-
very (for one-time installation) (see also Table 3).
Special tools (HVI cutter and HVI strip 20) should be used to cut HVI Conductors to length/shorten
® ® ®
HVI Conductors and the connection element/heat shrinkable sleeve should be attached considering
®
the relevant connection method (see 4., from page 16).
8