Inhaltsverzeichnis
Werbung
1 DEFAULT
UK
Read the RESTORE DEFAULT.
Leggere il codice che ripristina i default.
I
Lecture du code de configuration par défaut.
F
Lesen Sie den Restore Default Code, um die
D
Werkseinstellung wieder herzustellen.
DLC7070
RS232 DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,
ack/nack disabled, fifo enabled, delay disabled, rx timeout 5
sec., serial trigger lock disabled;
DATA FORMAT
= CR-LF
WEDGE DEFAULT SETTINGS
USA keyboard, caps lock off, delays disabled, control
character emulation = ctrl+shift+key;
DATA FORMAT
= ENTER
PEN DEFAULT SETTINGS
interpret mode, conversion to code 39 disabled, output level
normal, idle level normal, minimum output pulse 600 µs,
overflow medium
POWER SAVE
standby disabled, Illuminator off before beep, sleep disabled
READING PARAMETERS
trigger type = hardware, trigger signal = level, no timeout,
Flash On = 1 sec, Flash Off = .6 sec, one read per cycle,
safety time .5 sec, beeper intensity high, tone 2, factory
software focus range
RESTORE DEFAULT
: code identifier disabled, no header, terminator
: code identifier disabled, no header, terminator
Werbung
Inhaltsverzeichnis
