Verwandte Anleitungen für Datalogic DLC7000 SERIES CCD READERS
Inhaltszusammenfassung für Datalogic DLC7000 SERIES CCD READERS
- Seite 1 DLC7000 SERIES CCD READERS QUICK REFERENCE INSTALLAZIONE RAPIDA INSTALLATION RAPIDE SCHNELLINSTALLATION 820000157 (Rev. G)
- Seite 2 USING DLC7000 CCD GUNS DLC7000 CCD GUNS automatically scan barcodes at a distance. Simply aim and pull the trigger. Code scanning is performed along the center of the light bar emitted from the reading window . This bar must cover the entire code. Successful scanning is obtained by tilting the scanner with respect to the barcode to avoid direct reflections which impair the reading performance, see the figure above.
- Seite 3 DLC7000 READING DIAGRAMS DLC7070 Datalogic test chart (PCS=90%) Skew angle 10° (cm) 0.33 mm 0.5 mm 0.15 mm 1.0 mm DLC7072 0.33 mm 0.13 mm 0.15 mm (cm ) DLC7075 0.33 mm 0.50 mm 1.00 mm...
- Seite 4 CONNECTIONS RS232 With the RS232 cable, this accessory device is intended to be supplied by a UL Listed Direct Plug-in Power Unit marked "Class 2", rated 5 V, minimum 150 mA. WEDGE With the Wedge or PC Notebook cables, this accessory device is intended to be connected to a UL Listed Computer which supplies power directly to the reader.
-
Seite 5: Disconnecting The Cable
Pen cable Multidrop network or other Portable Host system terminal A F1 C F2 E F3 func I PG G CL Pen cable With the Pen Emulation cable, this accessory device is intended to be supplied by a UL Listed Power Unit marked "Class 2", or an LPS power source which supplies power directly to the reader. -
Seite 6: Technical Features
Max. resolution 0.13 mm, 0.08 mm, 0.13 mm, 5 mils 3 mils 5 mils min. 15% (Datalogic Test Chart) Reading indicators LED, Beeper Environmental Features 0 °C to + 55 °C Working Temperature -20 °C to + 70 °C Storage Temperature... -
Seite 7: Restore Default
1 DEFAULT Read the RESTORE DEFAULT. Leggere il codice che ripristina i default. Lecture du code de configuration par défaut. Lesen Sie den Restore Default Code, um die Werkseinstellung wieder herzustellen. RESTORE DEFAULT DLC7070 RS232 DEFAULT SETTINGS 9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking, ack/nack disabled, fifo enabled, delay disabled, rx timeout 5 sec., serial trigger lock disabled;... - Seite 8 DLC7070 DECODING PARAMETERS ink spread enabled, overflow control enabled, interdigit control enabled, decoding safety = one read CODE SELECTION enabled codes • EAN 8/EAN 13 / UPC A/UPC E without ADD ON check digit transmitted, no conversions • Interleaved 2/5 check digit control and transmission, variable length code;...
- Seite 9 DLC7072 / DLC7075 RS232 DEFAULT SETTINGS 9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking, ack/nack disabled, fifo enabled, delay disabled, rx timeout 5 sec.; : code identifier disabled, no field adjustment, DATA FORMAT code length not transmitted, no header, terminator = CR-LF, character replacement disabled WEDGE DEFAULT SETTINGS USA keyboard, caps lock off, num lock unchanged, delays...
- Seite 10 DLC7072 / DLC7075 DECODING PARAMETERS ink spread enabled, overflow control enabled, interdigit control enabled, Puzzle Solver™ disabled, decoding safety = one read CODE SELECTION enabled codes • EAN 8/EAN 13 / UPC A/UPC E without ADD ON check digit transmitted, no conversions •...
- Seite 11 2 READER CONFIGURATION Read interface selection code your application. Leggere il codice per la selezione dell’interfaccia relativo al modo di comunicazione desiderato. Lecture du code “Interface” correspondant à votre modèle. Lesen Sie denjenigen Schnittstellen-Code, der Ihrem gewünschten Kommunikationsmodus entspricht. RS232 WEDGE For All Models IBM AT or PS/2 PCs...
- Seite 12 WEDGE (continued) All Models IBM Terminal 3153 IBM Terminals 31xx, 32xx, 34xx, 37xx: To select the interface for these IBM Terminals, read the correct KEY TRANSMISSION code. Select the KEYBOARD TYPE if necessary (default = advanced keyboard). Per selezionare l'interfaccia per i terminali IBM, leg- gere il codice Key Transmission appropriato e, se necessario, il codice Keyboard Type (default = advanced keyboard).
- Seite 13 WEDGE (continued) DLC7072 / DLC7075 Only The following interface selection allows barcodes sent to the PC to be interpreted correctly independently from the Keyboard Nationality used. You do not need to make a Keyboard Nationality selection. (default = Num Lock Unchanged) Make sure the Num Lock key on your keyboard is ON.
- Seite 14 WEDGE (continued) DLC7072 / DLC7075 Only Wyse Terminals ANSI Keyboard PC Keyboard ASCII Keyboard VT220 style Keyboard Digital Terminals VT2xx/VT3xx/VT4xx APPLE ADB Bus...
-
Seite 15: Wedge Keyboard Nationality
WEDGE KEYBOARD NATIONALITY Wedge users should select one of the following WEDGE KEYBOARD NATIONALITY codes. Quando è selezionata l’interfaccia Wedge, leggere uno dei seguenti codici per impostare la nazionalità della tastiera. Pour l’interface Wedge, lire l'un des codes suivants pour sélectionner la nationalité du clavier. Für den Betrieb mit einer Wedge-Schnittstelle lesen Sie einen der folgenden Codes, um die Tastaturnationalität einzustellen. - Seite 16 YOUR READER IS NOW READY TO READ BARCODES. To change the defaults see the Hand-Held Devices Software Configuration Manual, part number 90ACC1854. IL LETTORE È PRONTO A LEGGERE I CODICI. Per cambiare i parametri di default, fare riferimento manuale "Hand-Held Devices Software Configuration Manual", n.
-
Seite 17: Operating Test
3 OPERATING TEST Read the TEST codes below. Leggere i codici di test. Lire les codes tests. Lesen Sie die Test-Coden. EAN-8 1 2 3 4 5 6 7 0 EAN-13 1 2 3 4 5 6 7 0 0 0 9 9 2 Code 39 (Normal) Code 128 Interleaved 2 of 5... -
Seite 18: Warranty
Datalogic garantit ce produit de tout défaut de fabrication ou des matériels pendant 24 mois de la date de livraison, à condition que le produit soit utlisé correctement. Datalogic a la faculté de réparer ou de remplacer ce produit. mesures prolongeront l’échéance de la garantie. -
Seite 19: Fcc Compliance
EP pat. Appl. 96EP-830.660; EP pat. Appl. 96EP-830.439 FCC COMPLIANCE Modifications or changes to this equipment without the expressed written approval of Datalogic could void the authority to use the equipment. This device complies with PART 15 of the FCC Rules. - Seite 20 DATALOGIC S.p.A., Via Candini, 2 40012 - Lippo di Calderara Bologna - Italy dichiara che declares that the déclare que le bescheinigt, daß das Gerät declare que el DLC7070-XX CCD Gun e tutti i suoi modelli and all its models et tous ses modèles...
- Seite 21 DATALOGIC S.p.A., Via Candini, 2 40012 - Lippo di Calderara Bologna - Italy dichiara che declares that the déclare que le bescheinigt, daß das Gerät declare que el DLC7072-M1; and DLC7075-M1 CCD Gun e tutti i suoi modelli and all its models et tous ses modèles...