Bauknecht DWGR 7880 ES Benutzerhandbuch Seite 15

INSTALLATION - ASSEMBLY INSTRUCTIONS
The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) given on the last pages of
this manual.
IMPORTANT: The hood comes as a filter version.
The carbon filter is supplied and must be fitted after installation.
1. Mark a vertical centre line on the wall.
2. Place the drilling diagram against the wall (fix it with adhesive tape): the vertical centre line printed on the drilling diagram must match the centre line
drawn on the wall.
Note: the bottom edge of the drilling diagram corresponds to the bottom edge of the hood.
IMPORTANT: The bottom edge of the drilling diagram must have a min. distance of 40 cm (for electric hobs) or 65 cm (for gas hobs).
3. Drill the 3 holes as shown on the drawing.
4. Remove the drilling diagram from the wall, insert the 2 plugs and the 2 screws in the wall, making sure they protrude about 5 mm; insert the third plug in
the bottom hole.
5. Fit the plastic grille on the hood air outlet hole
6. Hook the hood on the fixing screws through the special rear perforation.
7. Remove the extraction panel:
a. twist the panel upwards.
b. push the panel upwards firmly
c. remove the panel completely
8. Remove the grease filters.
9. Insert the washer and safety screw in the bottom hole.
10. Secure the hood to the wall by tightening down the fixing screws.
11. Fit the power cable in its special place.
12. Secure the cable to the cable clamp.
IMPORTANT: This operation is compulsory. It will prevent accidental disconnection of the power cable.
Carry out the connection to the household electrical system.
13. Fit the carbon filters over the motor covering. Turn the filters to secure them to the middle pins.
14. Re-fit the grease filters.
15. Re-fit the panels.
Check hood operation, referring to the section giving a description of the hood and its use.
GB13