teutonia SPIRIT S3 Bedienungsanleitung Seite 11

How to use the hood
Push the insert pieces for the hood joints into the cor-
responding openings on the armrest or on the carry-cot.
Attention: You must secure the press studs on the back
end of the cover onto the rear of the backrest as the co-
ver is also used as a protection against falling out.
If you need to remove the hood, undo the press studs on
the rear of the backrest; press the release buttons on
the insert pieces of the hood joints and pull the joints out
of the openings. You can open the zip at the top of the
hood for ventilation.
Adjusting the Backrest
Adjusting the footrest
Pull the grip 1 upwards and
move the backrest 2 into the
required position.
make sure that the backrest
re-engages properly.
Raise the footrest and allow
the bar to click into place in
the notch. When releasing it,
hold the bar in the centre of
the latching notch and raise
the footrest.
Using the Five-Point Harness
Open the harness by pressing both sides of the buckle
latches as shown in Figure 1. It is not necessary to sep-
arate the chest restraints from the crotch restraints. Sit
your child in the stroller, move both its arms through the
Please
harness opening and insert the buckle latch into the
crotch belt latch. Using the adjusters, adjust the harness
as shown in Figure 2.
Warning: Always use the crotch strap in combination with
the waist belt. Attaching points (D-ring) for a separate
belt harness are provided at the outer ends of the
crotch restraint.
Using the Reclined Surface Extension
(available as an accessory)
If you need to, you can attach the washable bed exten-
sions at the foot of the sports buggy inlay using the push
locks.
Safety bar
Push the insert pieces on the safety bar through the
slots in the seat cover into the receptacles beneath,
which are located in the armrests. Make sure that the sa-
fety bar has clicked into place on both sides. To remove
it, press the release buttons on the insert pieces. In or-
der to make it easier for your child to get in and out, it
suffices to release and fold up one side of the bar.
SPIRIT S3 INT
11