teutonia SPIRIT S3 Bedienungsanleitung Seite 10

INT SPIRIT S3
Assembling and removing the wheels
Removing the tilting unit
Tilting wheel
Tilting wheel locked
We recommend that you do not lock the wheels when
pushing the buggy in order to increase the comfort.
Seat cover
The seat cover can be completely removed from the seat
unit in order to be washed. To do this, press the press
studs on the seat unit.
The middle seat or reclining surface is designed as a
two-way seat. Release the side zips, pull the cover over
at the head end and the belt on the other side and
re-attach the centre piece on the sides.
Attention: When fitting the seat cover, please pull the
end of the 5-point harness back through the matching
openings without twisting it.
10
Before assembling or remo-
ving the wheels, press the
locking spring 1. When as-
sembling the wheels, make
sure that the locking spring
engages properly.
Press locking spring 1, hold
and remove the complete
tilting unit 2.
Take care during assembly
that the locking spring locks
properly.
Tilting wheel released
Height-Adjustable, Foldable Handle
Applying the Parking Brake
Fitting and Removing the seat unit
or the pram body (upper part)
Position the seat or pram body on the chassis so that the
bars 1 on each side engage in the provided four slots 2
and push in the seat or pram body as far as they will go.
The locks 3 will automatically latch.
Warning: Check that the pram body or seat unit attach-
ment devices are correctly engaged before use.
The upper part is secured when the red section behind
the locks is no longer visible. To remove the seat or pram
body press the locks down as far as it will go, then
remove the seat or pram body from the slots and lift off.
To change the height of the
handle, press in the adjusting
buttons on both sides of the
handle.
The brake is activated by
pushing down the long brake
lever 1. If it is difficult to
apply the brake, wheel the
stroller back and forth a few
centimetres so that the brake
bars engage properly in the
wheel rim. Make sure that
the brake has locked secure-
ly. You can release the brake
by depressing the brake lever
2.