Duplex Receivers REX Bedienungsanleitung Seite 14

computer radio control system
Output Period - output signal period setup (initial setup for the
Autosynchronizing mode with the transmitter). This parameter is
fundamentally influencing servo behaviour. With lower output
period values the reactions (response) of analog servos become
faster, but current consumption increases. With a too low setup
value some servos may even start chattering.
PPM-UDI Mode - data conversion mode can be:
Direct
output PPM signal contains data directly from the transmitter,
ź
without conversions and channel mapping
conversions and possible channel mapping are applied to
ź
output servo impulses only
different channels might be assigned to the PPM signal and
ź
servo output pins
Computed
conversions and prospective mappings are applied to output
ź
servo impulses and also to PPM signal
servo impulses and PPM signal contain the same information
ź
OutputChannelCnt - setup of generated number of receiver
outputs in PPM. If the receiver receives less channels than selected
in setup, the remaining channels (in Computed mode) will be
replaced by a throw specified by the Fail Safe value for individual
channels. Otherwise, the number of output pulses will be reduced
to the setup number.
13
EN