Receiver Set-Up Via The Dc/Ds Transmitter - Duplex Receivers REX Bedienungsanleitung

EN
computer radio control system
paragraph 5.1.1). Wireless connection is only possible when a
receiver is in"Normal" mode (MeasureOrSetting->Main Setting -
>Rx mode: Normal).
The JETIBOX can be disconnected only after you disconnect the
receiver voltage supply. You may monitor the on-board state of
your receiver during your model's operation. Pay particular
attention, of course, to your setup work. If it is possible, we do not
recommend changing setup parameters during model
operation. Set-up work should only be done if there is no danger
of damaging the model or injuring people. For safety reasons
prevent motor activation or remove the propeller!

5.2 Receiver set-up via the DC/DS transmitter

Please see information concerning receiver set-up via transmitters
in the DC/DS transmitter instruction manual. You can find the
DC/DS instructions on the manufacturer's website.
10