Cutting Angle Adjustment - jet promac SX-823DGVI Gebrauchsanleitung

SX-823DGVI / SX-827DGVI
A. Main connect switch
B. Manual/Auto selector
C. Indicator light
D. Auto start cutting button
E. Emergency push button
F. Blade Speed adjusting knob
G. Blade Speed display
5.3 Vise adjustment
- The device does not require any particular adjustment;
in case of excess play of the sliding guide, tighten slide
screw more.
To move the vise in either direction, the vise jaw must be
unlocked at two points.
- Release the track support by turning handle (1) counter-
clockwise.
- Release the vise by moving the lever (2) to the left.
- The vise (5) may now be moved to right position (7) or left
position (6) by pushing it with one hand on the vise and the
other hand on the track handle (1).
- Once in position, move the lever (2) to the right to lock it
into position.
- Lock the track support (1) by turning handle clockwise.
Clamping the Work Piece
- Place work piece between the jaws.
- Use the hand wheel to approach the vise jaws to the work
piece, make the vise jaw to against the material. Lock the
work piece by push down the lever (4).
Push start cutting button (D). When the cutting cycle is
finished, release vise by pulling lever (4) up. Upon releasing
the lever (4), the vise jaw will open. This allows for rapid
loading of same size material.

5.4 Cutting angle adjustment

Cutting at angles
- Using the right side, angles can be cut up to 60 degrees.
This requires that vise jaw to be set on the left side (6).
- Using the left side, angles can be cut up to 45 degrees.
This requires the vise jaw to be set on the right side (7).
- Unlock lever (3) and rotate the saw frame arm until you
reach mechanical stop and check if the index corresponds to
45 degrees; if not, operate on the set screws to make
measures meet.
5.5 The base
- A structure supporting the SAW ARM (revolving arm for
gradual cutting and respective blocking system), the VISE,
the BAR STOP, the ROLLER for the support of the material.
The base houses the cooling liquid TANK and PUMP.
6