jet promac SX-823DGVI Gebrauchsanleitung Seite 17

Another advantage offered in the use of this type of blade
in the fact that with an only blade it is possible to cut a
wide range of different materials in size and type.
COMBO TOOTH: 9º - 10º positive rake.
This type of blade is the most suitable for the cutting of
section bars and large and thick pipes as well as for the
cutting of solid bars at maximum machine capacity.
Available pitches: 3-4/4-6.
SETS
Saw teeth bent out of the plane of the saw body, resulting
in a wide cut in the workpiece.
REGULAR OR RAKER SET: Cutting teeth right and left,
alternated by a straight tooth.
Of general use for materials with dimensions superior to 5
mm. Used for the cutting of steel, castings and hard
nonferrous materials.
WAVY SET: Set in smooth waves.
This set is associated with very fine teeth and it is mainly
used for the cutting of pipes and thin section bars (from 1
to 3 mm).
ALTERNATE SET (IN GROUPS): Groups of cutting teeth
right and left, alternated by a straight tooth.
This set is associated with very fine teeth and it is used
for extremely thin materials (less than 1mm).
ALTERNATE SET (INDIVIDUAL TEETH): Cutting teeth right
and left.
This set is used for the cutting of nonferrous soft materials,
plastics and wood.
15