jet promac SX-823DGVI Gebrauchsanleitung Seite 14

8.2 Weekly maintenance
- Thorough cleaning of the machine to remove shavings,
especially from the lubricant fluid tank.
- Removal of pump from its housing, cleaning of the
suction filter and suction zone.
- Clean the filter of the pump suction head and the
suction area.
- Use compressed air to clean the blade guides (guide
bearings and drain hole of the lubricating cooling).
- Cleaning flywheel housings and blade sliding surfaces
on flywheels.
8.3 Monthly maintenance
- Check the tightening of the blade wheel screws.
- Check that the blade guide bearings on the heads are
perfect running condition.
- Check the tightening of the screws of the gear motor,
pump, and accident protection guarding.
8.4 Six-monthly maintenance
- Continuity test of the equipment potential protection
circuit.
8.5 Maintenance of other machine parts
The worm drive gearbox mounted on the machine is
maintenance-free guaranteed by its manufacture.
8.6 Öle für das schmierfähige Kühlmittel
Verwenden Sie das biologisch abbaubare
Kühlschmiermittel Art.: 9176. DER MINIMALE
PROZENTSATZ VON ÖL IN WASSER GELÖST
SOLLTE 8 - 10 % BETRAGEN.
8.7 Oils for lubricating coolant
Considering the vast range of products on the market, the
user can choose the one most suited to their own
requirements, using as reference the type SHELL LUTEM
OIL ECO. THE MINIMUM PERCENTAGE OF OIL
DILUTED IN WATER IS 8 - 10 %.
8.8 The gear box
The gearbox requires periodic changing of oil. The oil must
be changed by the first 6 months of a new machine and
every year thereafter.
To change the gear box oil
- Disconnect the machine from the power source.
- Raise the saw arm to vertical position
- Release the drain hole (O) to draw off gear oil by loosening
the hex socket screw (O).
- Replace the screw (O) after oil completely flows off.
- Place the saw arm back to horizontal position.
- Fill Gear box with approximately .3 liter of gear oil through
the hole of the vent screw (Q)
For reference, use SHELL type gear oil or Mobile gear oil
#90.
8.9 Special maintenance
Special maintenance must be conducted by skilled personnel.
We advise contacting your nearest dealer and/or importer.
Also the reset of protective and safety equipment and
devices (of the reducer), the motor, the motor pump, and
other electrical components requires special maintenance.
12