urmet domus 1183/3 Bedienungsanleitung Seite 7

LINE TERMINAL SETTINGS
A line terminal jumper is fi tted in the door phone. Activate the terminal for devices wired at the end of a line
from which another section does not start from the device terminals (end of line):
Termination
ON
Termination
LINE OUT
OFF
LINE 3 LINE 1
LINE 4 LINE 2
LINE IN
PERFORMANCE
CALL RECEPTION
The user's apartment station will ring with the programmed tone when a call is received according to the
source:
• From main door unit
• From secondary door unit
• Intercom call
• Floor calls
• From switchboard
The electric lock can be operated from the calling door unit also without picking up the handset when a call
is received.
Indoor station 0 will ring immediately if there are several stations in the apartment. Extensions 1, 2 and 3 will
ring in sequence after each other.
12
Line termination
OFF ON
Termination Termination
ON ON
LINE OUT
LINE 3 LINE 1
LINE 4 LINE 2
LINE IN
DS1183-005
INTERCOM CALL FORWARDING
After programming the button for the intercom function, pickup the handset and press the button.
The following cases can occur according to the calling indoor station state:
• Indoor station free: the calling indoor station will output a confi rmation tone (2 beeps) and the called
indoor station will ring. Communication is established when the called user picks up.
• Indoor station busy: the indoor station outputs a warning tone (4 beeps in rapid sequence). Hang up and
try again later.
FLOOR CALL FUNCTION
The indoor station is equipped with a pair of terminals (CP) for connecting the fl oor call button. The indoor
station will ring with the set tone for 3s when the button is pressed. Connect this button only to one indoor
station if there are several indoor stations in parallel. Extensions 1, 2 and 3 will ring in sequence after each
other.
ADDITIONAL RINGER MANAGEMENT
The door phone is equipped with a pair of terminals (S-, S+) for connecting a supplementary ringer or a
relay. This ringer is controlled when any call tone is generated.
ADJUSTING CALL VOLUME
MAX
Maximum calling
volume
AUTOMATIC DOOR LOCK RELEASE
This feature allows to automatically send a pedestrian door lock release command after a call coming from
door units. This feature can be activated/deactivated with the button no. 7 and is signalled by turning on
the led on the button.
OPEN DOOR LED / AUTOMATIC DOOR LOCK RELEASE
The door phone is provided with a led that signals open door state or automatic door lock release feature
active.
To signal an open door in a main call module, the led is steady on; to signal an open door in a secondary
call module the led blinks fast; to signal an automatic door lock release feature active the led blinks slowly.
Automatic door lock release signalling has priority over open door signal.
Open door signalling is active only on the last called door phone where the door lock release button has
been pressed. This signalling is referred to the last calling door unit.
§
Open door signalling is available only if a suitable sensor has been connected to the door unit.
DS1183-005
Red
MIN MUTE
Minimum calling No calling tone
volume
13