Special Features - Austro Flamm TOWER XTRA 2.0 Benutzerhandbuch

Tower Xtra 2.0
5. SPECIAL FEATURES TOWER Xtra 2.0
Xtra heat storing technology
The model Tower Xtra 2.0 has been equipped with the unique Xtra heat storing technology. This technology is based on the
patented Heat Memory System, but also on the special flue gas guidance and the convection air which can be regulated or
shut off completely. Consequently a fast heating system is being combined with an extraordinarily efficient heat storing.
The convection air can be regulated according to demand with the attached lever (see picture). The more the convection air
outlets of the top plate are open, the faster heat but less heat storing can be reached. A closed top plate will however lead to
slow heat and longer heat storing.
Our hint: while the fire still burns let the convection air outlets open; close them after the fire has burnt down in order to reach
a steady heat emission.
Operation with external air supply
Tower Xtra 2.0 can be operated with an external air connection. If the combustion air is being supplied directly to the furnace
by an air-tight pipe including closing mechanism from the outside, then the stove may be used in residential property with
mechanical ventilation.
Attention – all gaskets must be inspected periodically for tightness and have to be replaced if necessary.
If the stove in being used like that, a multiple stove installation on the same chimney is forbidden.
This stove has been approved by the German DIBT.
problem
door glass gets sooty too fast
stove does not get
combustion air
stove smells strongly and there is
smoke on the outside surface
exhaust gas emission
putting more wood on the fire and
during operation
possible reason
bad chimney draught
incorrect use of the combustion
air supply lever
wood logs are too large
operating temperature was not
reached
chimney draught not sufficient
enough
stove is sooted inside
baking phase of the varnish
stove is dusty/dirty
chimney draught no sufficient,
flue pipe connection leaky
while
the stove door was opened
before the wood has burnt down
to embers
8
solution
generally: door glasses must be cleaned with
Austroflamm glass cleaner from time to time
(depending on the frequency of use)
contact your
chimney/draught metering)
please operate air lever according to user's
instructions (if secondary air is closed, the door
glass soots rather fast)
keep to the max. fuel quantity according to user's
instruction
more fuel, use dry wood (< 15 % residual moisture),
attend air regulation
contact your
chimney/draught metering)
more fuel, use dry wood (< 15 % residual moisture),
attend air regulation
there may be some odour development during the
first operations
cleaning before the heating season starts!
inspect joints and seal up again if necessary
check chimney draught, examine operating - for info
video
http://www.austroflamm.com/de/Video/index.html
put more fuel wood into the combustion chamber
only if there are only embers left (no more visible
flame)
chimney sweep (elongate
chimney sweep (elongate
english
follow: