Operation - Laserworld PM-1200RGB LD Bedienungsanleitung

Manual: Pure Micro Series

8. Operation

1. Please notice:
Always connect the device to the power supply first before connecting it to the
grid.
Make sure that your device is provided with the correct voltage. Wrong voltage could
lead to irreparable damages. Please find the correct voltage data in the synoptical table
at the end of this manual. It must be ensured that the device is not directed to people or
inflammable objects during installation.
The "Power" diode on the rear side of the device begins to light up after the device
has been connected to power.
2. ILDA in / ILDA out
The device can be controlled via ILDA control signal. There are a ILDA-in (ILDA input)
and a ILDA-out (ILDA output) interface on the rear side of the device. Connect the laser
system to the control interface (DAC) by using an ILDA cable. Do not connect the laser
to standard parallel port at your computer, but always use an appropriate ILDA inter-
face (usually is sold together with the laser control software). After that you are able to
control your laser by a showlaser software (e.g. Phoenix or Pangolin). Use the ILDA-out
interface to daisy-chain the signals (from ILDA-in) to a further device.
3. X/Y Axis
There are two trim pots for X and Y axis adjustments on the rear side of the unit. Use the
X-Axis pot to vary or to glean the picture along the x-axis. Use the Y-Axis pot to vary or to
glean the picture along the Y-axis. Avoid that both pots are set to centerposition at the
same time. Otherwise the power density of the beam gets extremly high! (You can avoid
this by activating the safety with beam block.)
4. Colors
The trim pots Red, Green and Blue on the rear side of the device can be used to adjust the
single colors in their color balance.
Red: Turn the „Red"- pot to adjust the red color balance.
Green: Turn the „Green"- pot to adjust the green color balance.
Blue: Turn the „Blue"- pot to adjust the blue color balance.
5. Overheat
Find the "Overheat"-LED below the "Power"-LED on the rear side of the device. By de-
fault the unit has an integrated protection against overheating. To avoid overheating,
the overheat control reduces the output power without switching the device off. If the
temperature of the device (not air temperature) becomes to high, the overheat LED lights
up and the output power of the device gets reduced. Please improve ventilation if the
Overheat LED lights up
page 7 / 29
.