Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
• Make a hole with a diameter of 240mm. This is very easy when you use the carton that is
inside of the box .
• Take the grille from the speaker and put the speaker in the hole.
• Tighten the screws of the speaker so that the speaker will be clasped on the ceiling or wall.
• Inside of the box, you can find gums. Put these gums on the sides of the grille. Then put the
grille on the speaker. The gums on the sides of the grille will prevent the grille from falling
down.
Connections
Impedance
• Plug the speaker cable into the socket at the back of the speaker. Make sure to match the
impedance. Always plug one cable into the common socket and the other cable into the
socket of the desired power tapping.
Cable
• Be sure that you use the following polarities for your speaker cable when using several
speakers in the same location.
Red : Negative or common
Black : Positive
• The total rated input of all connected speakers may not exceed the amplifiers output.
3 3 3 3
Werbung
