The housing is made of strong, white ABS material and is waterproof. The AWP06 can be used in a 100V PA system with tapping for 6 W or 3 W or in low impedance systems 8 Ohm/6...
Seite 5
Warning Use only the correct amplifier output voltage and impedance, exceeding these limits could cause fire or other failures. Avoid explosions: do not use the speaker around gasoline, thinner or other combustibles. Only install the speaker in locations that can structurally support the weight of the speaker.
Installation Make a hole with a diameter of 140 mm This is very easy when you use the carton that is inside of the box. Install the unit only in a ceiling made of strong material so that the mounting springs don’t damage the ceiling.
Additional information Technical Specifications RMS Power Max Power 10 W Impedance 8 Ohm Line transformer power tappings 6 W / 1666 Ohm 3 W / 3333 Ohm 1,5 W / 6666 Ohm Sound pressure 1W / 1m 87 dB Sound pressure max W / 1m 95 dB Frequency response -3 dB 100 Hz –...
Seite 8
Deckenlautsprecher AWP06 AUDAC PROFESSIONAL AUDIO EQUIPMENT Deckenlautsprecher AWP06 Bedienungsanleitung & Installationsleitfaden...
Seite 9
A U D A C P R O F E S S I O N A L A U D I O E Q U I P M E N T Bedienungsanleitung AUDAC http://www.audac.eu info@audac.eu...
Seite 10
Index EINFÜHRUNG ..........................................3 WARNUNG -ACHTUNG ........................................4 INSTALLATION ..........................................5 ANSCHLÜSSE ............................................ 5 HINZUKOMMENDE INFORMATIONEN ..................................6 TECHNISCHE DATEN ....................................... 6...
Frequenzgang versichern eine sehr zuverlässige Musik- und Sprachreproduktion mit eine niedrige Distorsion. Das Gehäuse besteht aus starkem, weißem ABS Material für 6 W oder 3 W oder in einem System mit niedrigen Impedanz 8 Ohm/6 W. Der AWP06 Deckenlautsprecher stimmt überein mit den IP65 Standards.
Seite 12
Warnung Gebrauchen Sie nur die richtige Verstärker Output Spannung und die richtige Impedanz. Diese Limits überschreiten, kann Brand oder Störungen verursachen. Vermeiden Sie Explosionen: benutzen Sie den Lautsprecher nicht in der Nähe von Benzin, Verdünnung oder anderem brennbares Material. ...
Installation Machen Sie ein Loch von 140 mm in der Decke. Verwenden Sie dafür den Karton dass sich in der Dose befind. Installieren Sie den Lautsprecher in einer Decke, die aus starkem Material besteht so dass Sie die Decke nicht beschädigen. Für zartes Material können Sie ein Brett befestigen an der Decke und darin ein Loch machen.
Hinzukommende Informationen Technische Daten RMS Leistung Max Leistung 10 W Impedanz 8 Ohm Line transformator Impedanz 6 W / 1666 Ohm 3 W / 3333 Ohm 1,5 W / 6666 Ohm SPL 1W / 1m 87 dB SPL max W / 1m 95 dB Frequenzgang -3 dB 100 Hz –...